Fungal spore adhesion on glycidoxypropyltrimethoxy silane modified silica nanoparticle surfaces as revealed by single cell force spectroscopy.

Thin film coatings prepared from commercially available glycidoxypropyltrimethoxysilane (GPS) modified silica nanoparticles (SiNPs) (Bindzil® CC301 and Bindzil® CC302) have previously shown excellent antifouling performance against a broad range of microbes [Molino et al., "Hydration layer structure of biofouling-resistant nanoparticles," ACS Nano 12, 11610 (2018)]. In this work, single cell force spectroscopy (SCFS) was used to measure the biological interactions between Epicoccum nigrum fungal spores and the same silica nanoparticle-based surfaces used in the aforementioned study, including a: glass coverslip, unmodified SiNP coatings, and both low (Bindzil® CC301) and high density (CC302) GPS functionalized SiNP coatings as a function of NaCl concentration. From the SCFS curves, the spore adhesion to the surface was greatest on the glass coverslip (20-80 nN) followed by the unmodified SiNP (3-5 nN) across all salt concentrations. Upon approach to both surfaces, the spores showed a long-range attraction generally with a profile characteristic of biointeractions and likely those of the outer cell wall structures or biological constituents. The attractive force allowed the spores to initially adhere to the surface and was found to be linearly proportional to the spore adhesion. In comparison, both high and low density GPS-SINP significantly reduced the spore adhesion (0.5-0.9 nN). In addition, the spore adhesion on high density GPS-SiNP occurred in only 14%-27% of SCFS curves (40%-48% for low density GPS-SiNP) compared to 83%-97% for the unmodified SiNP, indicating that in most cases the GPS functionalization completely prevented spore adhesion. The GPS-SiNP surfaces conversely showed a long-range electrostatic repulsion at low 1mM NaCl that was replaced by short-range repulsion at the higher salt concentrations. From the findings, it is proposed that the attractive force is a critical step in initial adhesion processes of the spore. The effective antifouling properties of the GPS are attributed to the ability to negate the attractive forces, either through electrostatic repulsion in low salt conditions and primarily from short-range repulsion correlating to the previously reported combined steric-hydration effect of the GPS functionalization on SiNP coatings.

Modified silica nanoparticle coatings: Dual antifouling effects of self-assembled quaternary ammonium and zwitterionic silanes.

This work examines the antifouling effect of quaternary ammonium silane (QAS) grafted from coatings of silica nanoparticles (SiNPs), independently and in combination with a zwitterionic sulfobetaine (SB) silane. The binding of QAS to the SiNP coatings was monitored using quartz crystal microgravimetry with dissipation monitoring (QCM-D) under varied pH and solution concentrations. Adsorption of bovine serum albumin protein was reduced on QAS modified SiNP coatings prepared under alkaline conditions due to the proposed generation of a pseudozwitterionic interface, where the underlying SiNP surface presents an anionic charge at high pH. Significant reductions in protein binding were achieved at low functionalization concentrations and short modification times. Additionally, SiNP coatings modified with a combination of QAS and SB chemistries were investigated. Surface modifications were performed sequentially, varying silane concentration and order of addition, and monitored using QCM-D. Dual-functionalized surfaces presented enhanced resistance to protein adsorption compared to QAS or SB modified surfaces alone, even at low functionalization concentrations. The antiadhesive and antibacterial properties of functionalized surfaces were investigated by challenging the surfaces against the bacterium Escherichia coli. All dual-functionalized coatings showed equal or reduced bacterial adhesion compared to QAS and SB functionalizations alone, while coatings functionalized with high concentrations of combined chemistries reduced the adhesion of bacteria by up to 95% compared to control SiNP surfaces.

Carboxybetaine functionalized nanosilicas as protein resistant surface coatings.

Materials with protein resistant properties are increasingly sought after for their potential application as low-fouling surface coatings. Hydrophilic coatings with improved resistance to protein fouling have been prepared from zwitterionic carboxybetaine (CB) functionalized silica nanoparticles (SiNPs). The authors report three methods of coating preparation via direct tethering of CB to predeposited particle films, a two-step surface functionalization process, and deposition of CB functionalized particle dispersions. The pH at which aqueous CB solutions were prepared and reacted to SiNPs was found to drastically influence the mechanism of CB attachment and affect the protein resistance of the resultant coatings. Depending on the method of coating preparation, protein binding to functionalized particle coatings was reduced by up to 94% compared to unfunctionalized SiNP control surfaces. As a result, all three methods offer simple and scalable fabrication routes for the generation of hydrophilic, zwitterionic interfaces with improved inhibition to protein fouling.

Zwitterion Functionalized Silica Nanoparticle Coatings: The Effect of Particle Size on Protein, Bacteria, and Fungal Spore Adhesion.

The negative impacts that arise from biological fouling of surfaces have driven the development of coatings with unique physical and chemical properties that are able to prevent interactions with fouling species. Here, we report on low-fouling hydrophilic coatings presenting nanoscaled features prepared from different size silica nanoparticles (SiNPs) functionalized with zwitterionic chemistries. Zwitterionic sulfobetaine siloxane (SB) was reacted to SiNPs ranging in size from 7 to 75 nm. Particle stability and grafting density were confirmed using dynamic light scattering and thermogravimetric analysis. Thin coatings of nanoparticles were prepared by spin-coating aqueous particle suspensions. The resulting coatings were characterized using scanning electron microscopy, atomic force microscopy, and contact angle goniometry. SB functionalized particle coatings displayed increased hydrophilicity compared to unmodified particle coating controls while increasing particle size correlated with increased coating roughness and increased surface area. Coatings of zwitterated particles demonstrated a high degree of nonspecific protein resistance, as measured by quartz crystal microgravimetry. Adsorption of bovine serum albumin and hydrophobin proteins were reduced by up to 91 and 94%, respectively. Adhesion of bacteria ( Escherichia coli) to zwitterion modified particle coatings were also significantly reduced over both short and long-term assays. Maximum reductions of 97% and 94% were achieved over 2 and 24 h assay periods, respectively. For unmodified particle coatings, protein adsorption and bacterial adhesion were generally reduced with increasing particle size. Adhesion of fungal spores to SB modified SiNP coatings was also reduced, however no clear trends in relation to particle size were demonstrated.

Hydration Layer Structure of Biofouling-Resistant Nanoparticles.

Hydrophilic surface chemistries can strongly bind water to produce surfaces that are highly resistant to protein adsorption and fouling. The interfacial bound water and its distinct properties have intrigued researchers for decades, yet the relationship between the water three-dimensional structure and function in antifouling coatings remains elusive. Here, we use hydrophilic, epoxy organosilane modified silica nanoparticles to demonstrate cheap, robust, and practically applied coatings that we discover have broad-ranging, ultralow fouling properties when challenged by various proteins, bacteria, and fungal spores. To understand their excellent antifouling properties, frequency modulation-atomic force microscopy is used to directly observe the interfacial water structure at subatomic resolution, which we validate using all-atom molecular dynamic simulations that strikingly predict similar structures of water layers on the original and ultralow fouling surfaces. The convergence of experimental and modeling data reveals that suitably spaced, flexible chains with hydrophilic groups interact with water molecules to produce a connective, quasi-stable layer, consisting of dynamic interfacial water, that provides a basis for antifouling performance of ultrathin, hydrophilic surface chemistries.

Silica Nanoparticles Functionalized with Zwitterionic Sulfobetaine Siloxane for Application as a Versatile Antifouling Coating System.

The growing need to develop surfaces able to effectively resist biological fouling has resulted in the widespread investigation of nanomaterials with potential antifouling properties. However, the preparation of effective antifouling coatings is limited by the availability of reactive surface functional groups and our ability to carefully control and organize chemistries at a materials' interface. Here, we present two methods of preparing hydrophilic low-fouling surface coatings through reaction of silica-nanoparticle suspensions and predeposited silica-nanoparticle films with zwitterionic sulfobetaine (SB). Silica-nanoparticle suspensions were functionalized with SB across three pH conditions and deposited as thin films via a simple spin-coating process to generate hydrophilic antifouling coatings. In addition, coatings of predeposited silica nanoparticles were surface functionalized via exposure to zwitterionic solutions. Quartz crystal microgravimetry with dissipation monitoring was employed as a high throughput technique for monitoring and optimizing reaction to the silica-nanoparticle surfaces. Functionalization of nanoparticle films was rapid and could be achieved over a wide pH range and at low zwitterion concentrations. All functionalized particle surfaces presented a high degree of wettability and resulted in large reductions in adsorption of bovine serum albumin protein. Particle coatings also showed a reduction in adhesion of fungal spores (Epicoccum nigrum) and bacteria (Escherichia coli) by up to 87 and 96%, respectively. These results indicate the potential for functionalized nanosilicas to be further developed as versatile fouling-resistant coatings for widespread coating applications.